The panels are stood up one at a time and after the end wire staples are cut on each panel and the panels edges firmly butted together, the panel is fixed to the bottom rail using hooks and 'tek' screws (as shown in the preceding clip).  After all brushwood panels are  erected, prepared, butted and fixed in this fashion, the panel wires are then connected as shown here.

Alternative methods can be used to fix and join panels.  For example 2200mm wide panels can be supplied and fitted in-line with the posts (rather than the standard 1100mm wide panel which are fitted offset to the posts).  The wires can be tensioned around posts at either end using the extra long panel running wires.  Although the wider panels do not need to be connected to each other, handling and weight of these panels requires a two person installation, rather than the one person installation for our standard panel and system.